Demand test descriptions and error codes - Avaya Support

Table 361: Playback Speech Memory Array Test (#206) 2 of 2
Error
Code
Playback Speech Memory Array Test (#206)
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1 to
254
Test
Result
Description/ Recommendation
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Test failed. The error code indicates the number of byte count errors
found by the Tone Detector.
1. Reset the circuit pack via reset board location and then run
this test again. If the test continues to fail, replace the circuit pack
(see Warning).
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works (see Warning).
WARNING: Replacing
the circuit pack results in loss of integrated
announcements. Refer to General notes.
255 FAIL Test failed. The announcement Port and the Tone Detector never
synchronized. Check for active GPTD-PT errors, and refer to GPTD-PT
(General-Purpose Tone Detector Port) to diagnose them first.
1. If there are no active GPTD-PT errors, reset the circuit pack via
reset board location and then run this test again. If the test
continues to fail, replace the circuit pack (see Warning).
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works (see Warning).
WARNING: Replacing
the circuit pack results in loss of integrated
announcements. Refer to General notes.
PASS This port can cleanly play announcements. User-reported troubles on this
pack should be investigated using other port and circuit pack tests. Refer
to -BD (Announcement circuit pack) for a description of the circuit pack
tests.
2 of 2
Issue 5 May 2009 1287