Demand test descriptions and error codes - Avaya Support

DSP Port Status Query Test (#1407)
DSP Port Status Query Test (#1407)
This test queries the state of the DSP port. It runs on MEDPROPT (MEDPRO DSP PORT).
Table 532: DSP Port Status Query Test (#1407)
Error
Code
Test
Result
Description / Recommendation
1 ABORT This port is Out of service (OOS) due to:
● A board-level problem. For example, no IP address has been
translated for this location.
● A DSP hardware problem. See DSP Port Status Query Test
(#1407) and DSP Query Test (#1382).
2 ABORT This port has been made maintenance busy.
1002 ABORT The system could not allocate time slots for the test. The system may
be under heavy traffic conditions, or it may have time slots
out-of-service due to TDM-BUS errors. A system is considered under
heavy traffic when the Call Processing Occupancy is greater than
50% or when the System Management and the Call Processing
Occupancies together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received in the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
FAIL Unable to get status for this port. Verify that this board has been
administered correctly, and that there are no alarms against this board.
PASS The board is functioning properly and the port is in-service and
available.
0 NO
BOARD
See NO BOARD for repair procedures.
Issue 5 May 2009 1667