Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 427: Remote Layer 3 Query (#637) 2 of 3
Error
Code
1006 ABORT There are no associated B-Chels in an ISDN in-service or maintenance
service state.
For country protocol 1 interfaces (including the USA), either there are no
B-Chels administered in this signaling group, or all B-Chels in this
signaling group are either out-of-service or are in a “pending” state
(PINS or PMTC, indicating that a B-Chel maintenance message for that
B-Chel has been sent and not yet acknowledged).
This is a NORMAL ABORT.
1. Administer or release an ISDN trunk or PRI endpoint before
retrying the test. For an ISDN trunk, use status trunk grp#/
mem# to verify the ISDN trunk state. For a PRI endpoint, use
status pri-endpoint extension. Then, retry this test when
at least one B-Chel is in the in-service or maintenance states.
For systems not using country protocol 1 interfaces, there are no
B-Chels administered in this signaling group.
1019 ABORT There is already a Remote Layer 3 Query in progress. This is a normal
ABORT.
1. Wait two minutes, then follow the procedures for when this test
passes.
1113 ABORT The signaling chel is down. Therefore, no messages can be sent to the
far-end switch or terminal adapter.
1. Examine the results of Tests #636 and the Secondary Signaling
Link Hardware Check (#639) and follow recommendations
provided there.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2500
or
none
Test
Result
Description / Recommendation
ABORT Internal system error or administration problem
1. Determine whether any B-Chels are administered. If not, then this
is a normal ABORT since this test cot run unless at least one
B-Chel is administered. If at least one B-Chel is administered,
there is an internal system error. Retry the command at 1-minute
intervals up to 5 times.
FAIL Internal system error. See description of ABORT with Error Code 2500.
1430 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3