Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 469: SNI Sanity Timer Test (#964) 2 of 2
Error
Code
Test
Result
0 NO
BOARD
Description / Recommendation
No board was detected by the test.
1. Check that board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNI should be reset
instead of reseating the circuit pack. The reset board command
should almost never be used on an SNI. It may be necessary to use
reset board if the SNI circuit pack gets into a mode where it cot
communicate with software. If an SNI with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore
reset board can mask real problems.
3. Run the test again. If it fails, escalate the problem.
System Link Status Test (#985)
This test queries the switch for the status of the system link and verifies that every switch
component has the same view of the link state. This test runs on SYS-LINK (System Links)
Table 470: System Link Status Test (#985)
Error
Code
Test
Result
Description / Recommendation
1007 ABORT Could not locate the system link associated with this location
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
6 FAIL The system link is down.
1. Follow the procedure for Error Type 13 for SYS-LINK (System
Links).
PASS The system link is up.
1548 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2