Demand test descriptions and error codes - Avaya Support

Error log entries and recommended actions
Table 194: M/T-ANL Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test port location
1 (b) 41018 MIN ON test port location l r 3
18 0 busyout port
location
257 Any GPP NPE
Crosstalk Test (#9)
513 Any Analog Port Sanity
test (#963)
769 Any Analog Port Digital
Looparound (#13)
3840 (c) Any Hook State Inquiry
test (#566)
WRN OFF release port location
MIN ON test port location l r 3
MIN ON test port location r 2
MIN ON test port location r 3
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures. This Error Code
appears in the Error Log only if the MTB circuit pack has been removed since the Error Log
was last cleared. Verify that the circuit pack has been reinserted.
b. Error Type 1: a hardware failure on the Analog Port circuitry. Replace the Maintenance/Test
circuit pack if the command does not resolve the alarm.
c. Error Type 3840: call processing records did not agree with on-board records for the hook
state (on-/off-hook) of the Maintenance/Test analog port. This error is not service-affecting
and no action is required.
674 Maintenance Alarms for Communication Manager, Media Gateways and Servers