Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
The RC board must first be busied out in order for this test to run.
This tests validates the RC board circuitry by looping a 1004 Hz reflective tone to the far-end of
the RC circuit pack, then back to the processor. The Loopback Test is performed 24 times, once
for each NPE port.
This test aborts if any of the 24 tone loopback tests abort. This test fails if any of the 24 tone
loopback tests fail. If all 24 tone loopback tests pass, this test passes.
This test is run on RC-BD (Radio Controller Board).
Table 515: RC Tone Loopback Test (#1343) 1 of 2
Error
Code
Test
Result
Description / Recommendation
0 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1010 ABORT An attempt was made to busy out a circuit pack that was already
busied out. This error can be ignored.
1011 ABORT An attempt was made to release a circuit pack that was not busied out.
This error can be ignored.
1026 ABORT The TDM Bus cot be busied out because the control chel or the
system tones are present.
1362 ABORT The RC circuit pack has not been busied out.
1. Enter busyout board loc
2. Retry the test. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1-63 FAIL One or more of the 24 tone loopback tests failed.
1. Replace the RC circuit pack.
1644 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2