Demand test descriptions and error codes - Avaya Support

Table 229: SIP-SGRP Error Log Entries 2 of 2
Error
Type
1537 (i) Any MEDPRO Status test (#1392 MIN OFF
1794 (j) MEDPRO Status test (#1392) MIN OFF test signaling-group grp#
2561 (k) Any Registered to LSP Inline Error MIN OFF
3073 (l) 19 Far-end TLS Certificate Failure
Inline Error
3329 (m) 21 Near-end TLS Certificate failure
Inline Error
3585 (n) IP Signaling Far-end Status Test
(#1675)
3841 -
3942 (o)
Aux
Data
Associated Test Alarm
Level
On/Off
Board
MIN OFF
MIN OFF
MIN OFF
Recommended Action
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: Failure of the C-LAN hardware (IP-PROCR in S8300 systems) carrying the
signaling group chel.
To determine which C-LAN had been administered for this signaling group, find the
near-end node name on the signaling group form, then find the C-LAN or IP-PROCR
with the same node name on the ip-interfaces form.
Check for errors against the CLAN-BD MO.
c. Error Type 18: The signaling group has been busied out by command. Release the
signaling group, if appropriate, with release signaling-group grp#.
d. Error Type 257: Tracks failures of the SIP signaling-group PING test. See Signaling Group
Ping Test (#1387) for test failure information.
e. Error Type 513: Tracks excessive round-trip delay of the SIP signaling-group PING test, if
the round-trip delay exceeds 4 seconds. See Signaling Group Ping Test (#1387) for test
failure information.
f. Error Type: 770: Tracks excessive latency and packet-loss from background IP
measurements collected by the Media Processor Board. Indicates that test packets sent
from a media processor circuit pack to the far-end IP address specified on the
signaling-group form have exceeded the IP latency and loss thresholds, as
administered on the system-parameters ip-options form. Exceeding these
thresholds indicates that the IP network may not be providing sufficient quality of service for
830 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2