Demand test descriptions and error codes - Avaya Support

Table 438: FIBER-LK Configuration Audit (#759) 10 of 10
Error
Code
Test
Result
Description / Recommendation
SNC-BD Error codes and recommended actions
Configuration Audit (#759)
240 FAIL The SNI Endpoint 2 is physically connected to a DS1 converter, but is not
assigned to be connected to one.
1. Enter list fiber-link to display a fiber link’s endpoints.
Either replace the DS1 converter with fiber:
1. Enter list fiber-link to verify that the fiber-optic and metallic
cable connections are installed as assigned
2. Disconnect the SNI endpoint from the DS1 converter
3. Enter add fiber-link to reconnect the SNI to its assigned fiber
or
Add a DS1 converter complex to the SNI’s fiber:
1. Enter list fiber-link to locate this SNI endpoint’s fiber
2. Enter remove fiber-link for this SNI endpoint’s fiber
3. Enter add fiber-link to replace the fiber and to assign the DS1
Converter complex
PASS The administered data and the circuit packs the SNI(s) can communicate
with match.
The following table contains the error codes and recommended actions for SNC-BD (Switch
Node Clock Circuit Pack).
Table 439: SNC-BD Configuration Audit (#759) 1 of 5
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
2300 The downlink message necessary to run this test could not be sent.
10 of 10
1 of 5
Issue 5 May 2009 1469