Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 397: Digital Port Sanity Test (#565) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1019 ABORT An ISDN test call is in progress using this Maintenance/Test circuit pack.
The Maintenance/Test circuit pack cot perform a self-test on one of its
digital ports while an ISDN test call is using either of the digital ports.
1. Enter list isdnpri-testcall to determine which call is using
the port from the M/T Port column.
2. Wait for the test call to complete as indicated in the Start Time and
Duration fields, or abort the test call with clear
isdnpri-testcall grp#/mem#, where grp#/mem# is
determined from the B-Chel field of list isdnpri-testcall.
3. Retry the command at 1-minute intervals up to 5 times.
4. If the test continues to abort and the port is idle, escalate the problem.
1138 ABORT This test does not run on port 3 of the Maintenance/Test circuit pack. This
test will only run on port 2. Look at the results of the Digital Port Sanity test
for port 2.
1. Run the command again for port 2 using test port location
(02) or test port location (02) long.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2500 An internal operation failed; the test could not be completed.
1. Retry the command at 1-minute intervals up to 5 times.
50 FAIL The system was unable to communicate with the port circuitry used for
digital trunk testing.
1. Retry the command at 1-minute intervals up to 5 times.
1366 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3