Demand test descriptions and error codes - Avaya Support

End Loopback/Span Test (#1216)
This test is run on the DS1-BD (DS1 Interface Circuit Pack) and UDS1-BD (UDS1 Interface
Circuit Pack) maintenance objects.
Table 488: Inject Single Bit Error Test (#1215)
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry test ds1-loop location
inject-single-bit-error at 1-minute intervals up to 5 times.
1015 ABORT Ports on the DS1 Interface circuit pack have not been busied out.
1. Enter busyout board location to put all trunks or ports of the
DS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
2000 ABORT Response to the test was not received within the allowed time.
1. Check for board hyperactivity. See Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
PASS A single bit error has been successfully injected into an active framed
3-in-24 test pattern.
1. Enter release board location to release the trunks or ports.
0 NO
BOARD
See NO BOARD for repair procedures.
End Loopback/Span Test (#1216)
This test is destructive.
For documentation purposes, the term DS1 applies to the following:
DS1 Interface circuit packs
DS1 Interface media modules
UDS1 circuit packs.
Issue 5 May 2009 1595