Demand test descriptions and error codes - Avaya Support

Table 375: Expansion Interface Local Looparound Test (#240) 2 of 3
Error
Code
Test
Result
Description / Recommendation
Expansion Interface Local Looparound (#240)
1031 ABORT A query of the EI circuit pack aborted. The purpose of this query was to
see if the EI circuit pack could detect the framing signal.
1. If Test #238 aborted, follow the procedure associated with this
abort code.
2. If Test #238 did not abort, rerun Test #240 at 1-minute intervals up
to 3 times.
1032 ABORT The EI cot detect the framing signal and cot run the test.
1. Refer to the errors for Expansion Interface Fiber Out-of-Frame
Query Test (#238) to determine why the EI circuit pack is out of
frame.
1033 ABORT The EI circuit pack does not have a fiber link administered to it. There is
not sufficient data to run test.
1. Enter list fiber-link to verify that there is no fiber link
administered to this circuit pack.
2. If there is no fiber administered to this circuit pack, but there should
be, enter add fiber-link to add the correct fiber.
3. Retry the command.
1394 ABORT The EI circuit pack is out of service and the test cot be run. This
condition is due to a change in the EI circuit pack’s ability to
communicate with the EI or SNI circuit pack on the other end of the fiber.
1. Run Test #237, and check the Error Log for EXP-INTF Error Type
1281. If Error Type 1281 is present or if Test #237 does not pass,
see repair procedures for Expansion Interface Neighbor Query
Test (#237)
1395 ABORT This test cot be run on an EI circuit pack if it is part of the B-side PNC
and duplicated PNC is not enabled.
1. If this test needs to run on this EI circuit pack, enter
change system-parameters duplication to enable PNC.
2. Enter set pnc lock to prevent the system from doing a PNC
interchange.
3. Repeat this test.
2 of 3
Issue 5 May 2009 1313