Demand test descriptions and error codes - Avaya Support

MG-ANA (Analog Media Module)
The MG-ANA maintenance strategy supports the following:
Note: Too
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
MG-ANA MIN test board location long Analog Media
Module
WRN test board location
● MM711 (8 port analog line media module)
● MM714 (4 analog line ports + 4 analog trunk ports media module)
● MM716 (24 port analog media module)
● TIM508 (8 analog line ports for Juniper Media Gateways)
● TIM514 (4 analog trunk ports + 4 analog line ports for Juniper Media Gateways)
● TIM516 (16 analog line ports for Juniper Media Gateways)
● TIM518 (8 analog line ports and 8 analog trunk ports for Juniper Media Gateways)
● VMM_ANA (1 analog trunk port + 2 analog line virtual ports)
● VMM_42ANA (4 analog trunk ports + 2 analog line virtual ports)
Note:
many MM711 Analog Media Modules in a G700 might trip the G700
electronic breaker and cause the power supply for the entire G700 to shut down.
Error log entries and recommended actions
Table 180: MG-ANA Error Log Entries 1 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test board location
1 (b) 0 Board removed or SAKI Sanity
Failure (#53)
MIN ON
18 (c) 0 busyout board location WRN OFF release board location
23 (d) 0 WRN OFF
125 (e) MIN ON
626 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2