Demand test descriptions and error codes - Avaya Support

Table 349: TDM Bus Clock Parameter Update Test (#151)
Error
Code
Test
Result
Description / Recommendation
Analog Looparound Test (#161)
Analog Looparound Test (#161)
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS The IPSI or Processor/Tone-Clock circuit pack parameters have been
successfully updated.
The Analog Looparound Test checks the on-board transmission capabilities of the NPE, the
codec, and the battery feed chip of the analog port. The test passes if the signal measured by
the Tone Detector is within acceptable limits.
This test runs on the following maintenance objects:
● ADX16A-P (AUDIX Analog Line/Control Link)
● AN-LN-PT (Analog Line Port)
● ANL-16-L (16-Port Analog Line)
Table 350: Analog Looparound Test (#161) 1 of 4
Error
Code
Test
Result
Description / Recommendation
ABORT Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1 of 4
Issue 5 May 2009 1265