Demand test descriptions and error codes - Avaya Support

This test runs on FIBER-LK (Fiber Link).
Table 444: Fiber Link Reset Test (#768)
Error
Code
Test
Result
Failure Audit (#777)
Description / Recommendation
Failure Audit (#777)
1703 ABORT Both fiber endpoints are in the hardware path for INLs to their respective
switch node carriers and, therefore, cot get a response from this test.
1. Reset the individual fiber-link endpoints using reset board.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
PASS The reset of both fiber endpoints successfully completed.
This test queries the SNI(s) on the fiber link for any existing failures and unacknowledged
cleared failure messages. Each failure generates an error and alarm entry against SNI-BD,
SNI-PEER, or FIBER-LK. An unacknowledged cleared failure message is a message sent by
the SNI circuit pack to software indicating that a previous failure is now gone, and the SNI circuit
pack did not receive a message from software indicating that the failure message was received
by software.
If no failures are detected by the SNI circuit pack, this test will pass.
If this test reports failures, the results of test fiber-link will display FAIL with no FAIL
code. The error log must then be displayed using display errors with category PNC to view
SNI-BD and FIBER-LK errors. Enter display errors with category PNC-PEER to view
SNI-PEER errors.
This test is not run for EI-to-EI fiber links. For EI-to-SNI fiber links, this test is run on the SNI
circuit pack endpoint of the fiber link. For SNI-to-SNI fiber links, this test is run on both SNI
circuit pack endpoints of the fiber link.
This test runs on the following maintenance objects:
● FIBER-LK (Fiber Link)
● SNC-BD (Switch Node Clock Circuit Pack)
● SNC-LINK (Switch Node Clock Link)
● SNC-REF (Switch Node Clock Reference)
Issue 5 May 2009 1489