Demand test descriptions and error codes - Avaya Support

Playback Speech Memory Array Test (#206)
Notes:
a. The announcement circuit pack can exhibit a condition that does not allow recording.
If the circuit pack gets locked into this state (this is an extremely rare condition), two of the
announcement Ports on the circuit pack (one of which is the record port) is unusable by
software. Also, save/restore announcements do not work because the record port looks
busy to the circuit pack. The system does not have any way of knowing this and attempts to use
the ports.
If the circuit pack is locked into this state, the following symptoms are observed:
● When attempting to record an announcement, users hear the proper record tone, but the
announcement does not record. They do not know it until the announcement is played
back.
● The command test board location long returns the following abort codes:
● Ports 1 AND 9 abort Test #206 with error code 1024
● Ports 1 AND 9 abort Test #205 with error code 2000
● Board level Tests #209 and #210 abort with error code 1024
● Save/restore announcements times out with
Error encountered, can’t complete request
Clear the announcement circuit pack lock-up remotely by performing a soft reset on the circuit
pack. Note that the busyout command drops all calls in progress on the announcement circuit
pack.
Playback Speech Memory Array Test (#206)
The Playback Speech Memory Array (PSMA) test checks the integrity of a playback chel’s
interface to the speech memory and the TDM Bus. The SP has an internal buffer that contains a
specific 256-byte sequence. During this test, the byte sequence is "played" through the 140AY
device onto the TDM Bus. A General Purpose Tone Detector is used to confirm that the proper
sequence was played. This test is very important. It is the only test that actually checks an
announcement Port’s ability to play back an announcement on the TDM Bus. If the test fails, the
Tone Detector returns the number of bytes that did not match the expected sequence. The
larger the number, the more severe the problem with that port. If this test fails, announcements
played over this port should sound corrupted.
It is the only test that actually checks an announcement Port’s ability to play back an
announcement on the TDM Bus. If the test fails, the Tone Detector returns the number of bytes
that did not match the expected sequence. The larger the number, the more severe the problem
with that port. If this test fails, announcements played over this port should sound corrupted.
This test runs on -PT (Announcement Port).
Issue 5 May 2009 1285