Demand test descriptions and error codes - Avaya Support

XXX-BD (Common Port Circuit Pack/Media Module)
XXX-BD (Common Port Circuit Pack/Media Module)
MO Name
in Log
XXX-BD 1
Common Port Circuit Pack maintenance is a set of common tests used by many circuit packs
and media modules. The common portion of these circuit packs/media modules is the generic
hardware that interfaces with the TDM bus. The XXX-BD designation is also used on SAT
displays when reset board is entered with an empty circuit pack or media module slot, or
with a circuit pack or media module type that is in conflict with the actual board type
administered for that slot.
When any of the Common Port circuit packs or media modules are physically removed from the
backplane, no alarm will be logged for approximately 11 minutes. In the case of the following,
approximately 21 minutes will elapse before an alarm is logged:
● TN754 Digital Line
● TN758 Pooled Modem
Alarm Level Initial Command to Run Full Name of MO
MAJ
MIN
WRN
● TN566 EMBEDDED AUDIX
● TN2224 Digital Line Board
● MM712 Digital Line Media Module
● MM717 Digital Line Media Module
● MM720 BRI Media Module
● MM722 BRI Media Module
● MM312 Digital Line Media Module
● IMM-DCP Integrated Digital Line Board
● VMM-2BRI Integrated BRI Media Module
test board location Common Port Circuit Pack/
Media Module maintenance
1. Refer to the appropriate circuit pack or media module documentation for the correct MO name
displayed in this field.
● TIM521 Juniper BRI Media Module
When a circuit pack or media module that has been removed is alarmed, the alarm type is minor
and is classified as an on-board alarm. The time delay permits maintenance activity to be
performed without triggering an additional alarm.
Issue 5 May 2009 1065