Demand test descriptions and error codes - Avaya Support

Hyperactive DS1/UDS1 Interface Circuit Pack/Media Module
2. Verify that the board is properly translated and inserted by using list configuration.
Resolve any problems.
3. For DS1/UDS1 boards, use add ds1 location to administer the DS1 interface if it is
not already administered.
4. .If the board was already administered correctly, check the Error Log to determine whether
the board is hyperactive (Error Type 1538). If so, the board was shut down. Reseating the
board will re-initialize it.
5. If the circuit pack is correctly inserted, enter the following commands:
● busyout board location
● reset board location
● release board location
● test board location long
This should re-establish the linkage between the internal ID and the port. If not, verify that a
valid board is inserted.
Note: Hyperactivity
Note:
causes some special problems with the sequence suggested
above. If the ports are translated after entering list config but the Vintage
field reports that there is no board when there really is a board, then the busyout
board and release board commands will not work even though reset
board location will work. The switch will put the hyperactive board back in
service after the hyperactivity clears.
Hyperactive DS1/UDS1 Interface
Circuit Pack/Media Module
Error type 1538 in the error log indicates hyperactivity. The hyperactive DS1 board is out of
service and one or more of the following symptoms may be exhibited.
● The DS1 board tests such as test 138 and test 139 abort with error code 2000.
● The tests run on the ports are returning NO BOARD.
● A busyout or a release command has no affect on the test results.
● A list config command shows that the circuit pack or media module and the ports
are properly installed.
When hyperactivity occurs, the DS1 board is isolated from the system, and all of its trunks are
placed into the out-of-service state. The system will try to restore the DS1 board within 15
minutes. When no faults are detected for 15 minutes, the DS1 board is restored to normal
operation and every DS1 interface trunk is returned to the in-service state.
Issue 5 May 2009 1725