Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Test data patterns are transmitted from a Maintenance/Test board’s digital port over network
time slot A through the digital port on the conversion resource, looped around through the
analog port via time slot C back to the Maintenance/Test board’s digital port circuit via time slot
B where the patterns are checked for accuracy. Finally, the test forces a disconnect by breaking
the connection between the Maintenance/Test board’s digital port and the Modem Pool port
(time slot A) and verifying that the Maintenance/Test board’s digital port and Modem Pool port
go on-hook within the proper time. This test attempts to allocate a Maintenance/Test board’s
digital port, Modem Pool port, and other internal resources. If any of these allocation attempts
fail, the test cot be completed, and a specific abort error is reported.
This test runs on MODEM-PT (Modem Pool Port).
Table 321: Modem Pool Conversion Resource Looparound Test (#98) 1 of 5
Error
Code
1000
1180
1181
1182
Test
Result
Description / Recommendation
ABORT System resources needed to complete the test could not be allocated for
the digital section of the Modem Pool conversion resource. Ordinarily,
this means the conversion resource or other hardware used during the
test was in use.
1. Wait 1 minute and attempt the test again.
2. If the conversion resource is in use, and it is absolutely necessary
to test it, the call will have to be dropped by entering busyout
port location against the conversion resource.
3. Run the test again. If the test passes, release the port with
release port location
4. If the same error occurs while the conversion resource is idle,
busyout both Modem Pool conversion resources on the TN758
Pooled Modem circuit pack containing the conversion resource
under test. Rerun the test.
5. If the test continues to abort, replace the Pooled Modem circuit
pack and retest.
6. If the test continues to abort with this error code after replacement,
escalate the problem.
ABORT No time-slots available to connect digital ports for the test.
Internal system error. Failed to connect the digital ports with time-slots.
1. Retry the command at 1-minute intervals up to 5 times.
1196 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 5