Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
If there are any M/T-DIG errors in the Error Log, see M/T-BD (Maintenance/Test Circuit Pack)
and clear them first.
This test will pass regardless of any customer equipment that may be connected to the port, as
long as the equipment is not using the port.
This test runs on DAT-LINE (Data Line Port).
Table 358: Digital Looparound Test (#171) 1 of 4
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run test are not available. The port may be
in use on a valid call. Enter status data-module to determine when
the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1005
1007
ABORT Data Chel 3 is not administered. This port is required to run this test.
1. Verify that data chel 3 is not administered with
list data-module.
2. Administer data chel 3 with add data-module, and run this test
again.
1016 ABORT Data Chel 3 is busy. The port may be in use on a valid call. Enter status
data-module to determine when the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1020 ABORT An existing Error Type #769 on this port prevented the test from running.
1. Follow the procedure described in the Error Log Table for Error Type
#769 for this maintenance object.
1042 ABORT The port under test is a TTI port and has only default translations with no
assigned extension. The test requires an assigned extension associated
with the port being tested.
1. If there is a need to run the test on this particular port, verify that the
port is fully translated and has an assigned extension.
1276 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 4