Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 400: Maintenance/Test Circuit Pack Query Test (#572) 1 of 3
Error
Code
Test
Result
Description / Recommendation
1006 ABORT The packet bus port of the Maintenance/Test circuit pack is out of
service.
1. Determine whether the port is busied out. If so, release it with
release port location 04. Then retry the test command.
2. If there are alarms active against the packet bus port (MT-PKT),
see M/T-PKT (Maintenance/Test Packet Bus Port) to resolve them.
Then retry the test command.
1142 ABORT No Maintenance/Test circuit pack packet bus port is in service in this PN.
1. If this PN is required by configuration guidelines to have a
Maintenance/Test circuit pack, investigate the following:
● Check if the Maintenance/Test circuit pack has been busied
out. If so, release it and rerun the test.
● If i no Maintenance/Test circuit pack is installed in this PN, one
must be installed.
● Otherwise, the Maintenance/Test circuit pack for this PN has
failed and should be replaced
2. In a PN of a system without PNC duplication, the Maintenance/Test
packet bus Port is not required and may not be present. If it is
present and is busied out, or has failed, release or replace the
circuit pack. If there is no Maintenance/Test circuit pack, ignore the
results of this test for this PN.
2000 ABORT No response received within the allowed time.
1. Re-enter the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, look for M/T-PKT (Maintenance/Test
Packet Bus Port) errors in the Error and Alarm Logs.
2059 ABORT The Maintenance/Test packet bus port has reported a hardware failure.
1. See M/T-PKT (Maintenance/Test Packet Bus Port) to correct the
problem.
2. Rerun the test command.
1370 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3