Demand test descriptions and error codes - Avaya Support

CAB-PFL (Power Fan Lead)
G650
CAB-PFL (Power Fan Lead)
MO Name in Log Alarm Level Initial command to run Full name of MO
CAB-PFL MAJ MIN test environment location Power Fan Lead
The CAB-PFL represents the state of a combined power/fan lead. This lead is known as the
AuxSig lead. On a G650, the AuxSig output signal is a ground referenced relay contact closure
indicating a failure of the 655A power supply outputs, hot spot thermal warning, hot spot thermal
shutdown, or failure of the fan assembly in a G650.
Use the AuxSig lead to determine the alarm state of the power supplies and fans if the serial
bus or the interface to the serial bus of the TN2312BP IPSI in a G650 fails. If there is a
CAB-PFL alarm in a G650 carrier, there should also be a SER-BUS, POW-SUP, CAB-TEMP, or
PS-RGEN alarm indicating the source of the failure.
Refer to Figure 66: G650 Cabinet Environmental Hardware Components for further
information.
When the TN2312BP IPSI is used in a CMC1 or a G600 carrier, use the CAB-PFL MO to
determine the status of the power supply and fans, but use the repair procedure for RMC-ENV
(Power/Fan Sensors).
Fan/filter replacement procedures for the CMC1 and G600 media gateways are found under
Variable-speed fans in Maintenance Procedures for Avaya Aura Communication Manager,
Media Gateways and Servers (03-300432).
Error log entries and recommended actions
Table 66: CAB-PFL Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level 1
1 (a) Power/Fan Lead
Query Test (#1533) MAJ
MIN
On/Off
Board
Recommended Action
OFF test environment location
1. The alarm level of CAB-PFL is adjusted to be the same as the highest active alarm level for SER-BUS,
POW-SUP, CAB-TEMP, or PS-RGEN, or it will be a MAJOR alarm if no G650 alarms in that category
are found.
Note:
a. Error Type 1: The AuxSig lead is active. Run test environment location and follow
the repair steps for Power/Fan Lead Query Test (#1533).
Issue 5 May 2009 241