Demand test descriptions and error codes - Avaya Support

Table 65: CAB-MTCE Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
1025 (e) Reset Test (#1545) MIN ON test maintenance location
1281 (f) Environmental
Maintenance
Initialization Test
(#1548)
On/Off
Board
Notes:
a. Error Type 1—When a TN2312AP IPSI is inserted into a CMC1 or G650 Media Gateway, a
minor alarm is raised. Full environmental maintenance is NOT available. Replace the
TN2312AP IPSI with a TN2312BP IPSI. NOTE: A TN2312AP inserted in a G600 media
gateway does NOT raise any alarm or error.
b. Error Type 257—The test is unable to communicate with the TN2312BP IPSI board. NOTE:
The board must be a TN2312BP IPSI for this test to run.
c. Error Type 513—The TN2312BP sent a message with an unknown op-code in response to
the test. The unknown op-code is recorded under Aux Data.
d. Error Type 769—The TN2312BP sent a message with a valid op-code but some other part
of the message was indecipherable. The op-code with the error is recorded under Aux Data.
e. Error Type 1025—An attempt to reset environmental maintenance was unsuccessful.
f. Error Type 1281—Environmental initialization failed. Run the Reset Environmental
Maintenance Test (#1545), which calls the Environmental Maintenance Initialization Test
(#1548).
Demand test descriptions and error codes
MIN ON reset maintenance location
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of investigation Short test
sequence
1. D = Destructive, ND = Nondestructive
Recommended Action
Long test
sequence
240 Maintenance Alarms for Communication Manager, Media Gateways and Servers
D/ND 1
Correct Board Test (#1546) X X ND
Sanity Test (#1547) X X ND
Reset Environmental Maintenance Test (#1545) X D