Demand test descriptions and error codes - Avaya Support

Table 537: Long IP 2-Way Transmission Test (#1506) 3 of 3
Error
Code
20XX
XX = PN #
Test
Result
0 NO
BOARD
Description / Recommendation
Verify NIC Options Test (#1511)
Verify NIC Options Test (#1511)
FAIL The test tone was successfully sent from the IP Media Processor
specified in the test command and received by an IP Media Processor
in the PN specified in the error code XX.
The test tone was not successfully sent in the reverse direction.
Destination to source direction failed. Source to destination direction
passed.
1. Resolve all other board alarms for the specified source IP Media
Processor.
2. Resolve all other board alarms for the IP Media Processors in the
destination PN.
3. Use ping and traceroute to localize the problem to the
customer’s LAN/WAN IP network.
PASS The customer network is functioning properly. The test tone was
transmitted and received successfully between the IP Media Processor
specified in the test command and every other IP Media Processor in
the set of connected IP network regions.
See NO BOARD for repair procedures.
3 of 3
The Verify NIC Options Test checks if the circuit pack’s network interface parameters
(auto-negotiate, speed, and duplex) match with its administration.
The test passes if the NIC parameters match circuit pack administration. The test fails if the NIC
parameters do not match.
This test runs on IPMEDPRO (IP Media Processor) and ETH-PT (Control LAN Ethernet).
Issue 5 May 2009 1679