Demand test descriptions and error codes - Avaya Support

Communication Manager Maintenance Object Repair Procedures
AN-LN-PT (Analog Line Port)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
AN-LN-PT MIN test port location l Analog Line port
WRN test port location
The TN793B/TN2793B Analog Line circuit pack (w/ Caller ID) provides 24 ports for voice
terminals and supports both on-premises and off-premises analog voice terminals.
The TN797 Analog Trunk and Line circuit pack provides 8 ports, each of which may be
administered in any of several ways, as described in TR-LN-BD (Analog Trunk/Line Board).
The MM711 Analog Trunk and Line Media Module provides 8 ports. The MM716 provides 24
ports. Each of the ports may be administered in any of several ways, as described in MG-ANA
(Analog Media Module). Not all of the tests that run on the circuit packs are applicable to the
media modules. These tests will abort with error code 1412. This error can be ignored.
Ringing caused by maintenance testing
Test #48 may cause some terminal equipment to ring briefly during daily maintenance. If this
ringing disturbs the customer or the terminal equipment, disable it in the Tests field of the
change station extension form. Be aware that this action also disables Tests #6, 7, 161,
and 35 on some software releases.
Error log entries and recommended actions
Table 18: AN-LN-PT Error log entries 1 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
74 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Recommended Action
0 (a) 0 Any Any Any test port location
1 (b) 40960
40975
40977
none
15 (c) Any Port Audit and Update (#36)
18 0 busy station extension WRN ON release station extension
130 (d) None WRN ON test port location
1 of 2