Demand test descriptions and error codes - Avaya Support

SNI Fiber Out of Frame Query Test (#989)
SNI Fiber Out of Frame Query Test (#989)
This test performs a non-destructive facility test of the SNI. The SNI circuit pack reports whether
a fiber out of frame condition exists, whether a loss of signal condition exists, and whether the
lightwave transceiver is present.
This test runs on the following maintenance objects:
● FIBER-LK (Fiber Link)
● SNI-BD (SNI Circuit Pack)
● SNI-PEER (SNI Peer Link)
Table 471: SNI Fiber Out of Frame Query Test (#989) 1 of 8
Error
Code
1415
1416
Test
Result
Description / Recommendation
ABORT The lightwave transceiver is absent from Endpoint 1.
The lightwave transceiver is absent from Endpoint 2.
1. Enter list fiber-link to display fiber link endpoints.
2. If a lightwave transceiver should not be present, do nothing. For
example, an SNI connected to a DS1C circuit pack or an SNI with a
metallic connection does not have a lightwave transceiver.
3. Otherwise, check the lightwave transceiver connections. Check that
the lightwave transceivers are of the same type, that is, both are
9823a or both are 9823b. If they are not the same type, replace one
of the lightwave transceivers:
● 9823a is used for distances up to 4900 feet.
● 9823b is used for distances up to 25,000 feet.
4. If the test continues to abort, replace the SNI circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
2300 The downlink message necessary to run this test could not be sent.
2301 The timer could not be set before sending the downlink message.
2304 SNI circuit pack is not able to run the test requested by software.
1. Retry the command at 1-minute intervals up to 3 times.
1 of 8
Issue 5 May 2009 1549