Demand test descriptions and error codes - Avaya Support

Modem Pool Conversion Resource Looparound Test (#98)
Table 321: Modem Pool Conversion Resource Looparound Test (#98) 4 of 5
Error
Code
5000 ABORT Unable to allocate necessary resources for this test.System resources
needed to complete the test could not be allocated for the digital section
of the Modem Pool conversion resource. Ordinarily, this means the
conversion resource or other hardware used during the test was in use.
1. Wait 1 minute and attempt the test again.
2. If the conversion resource is in use, and it is absolutely necessary
to test it, the call will have to be dropped by entering busyout
port location against the conversion resource.
3. Run the test again. If the test passes, release the port with
release port location
4. If the same error occurs while the conversion resource is idle,
busyout both Modem Pool conversion resources on the TN758
Pooled Modem circuit pack containing the conversion resource
under test. Rerun the test.
5. If the test continues to abort, replace the Pooled Modem circuit
pack and retest.
6. If the test continues to abort with this error code after replacement,
escalate the problem.
5001
5002
5003
5004
5005
Test
Result
Description / Recommendation
ABORT Internal system error.
The data chel allocated for this test could not be seized
Unable to establish a connection to the Modem Pool Port.
1. Wait 1 minute, then retry the test up to 5 times.
2. If the same error persists after 5 attempts, escalate the problem.
ABORT Unable to allocate analog resources for this test.
Internal error.
1. See the repair procedure for Error Code 5000
4 of 5
Issue 5 May 2009 1199