Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Power Supply Temperature Test (#1537)
The power supply temperature test runs on CAB-TEMP (Cabinet Temperature). It provides the
status of the following temperatures:
● Inlet to the power supply (120F/49C)
● Carrier exhaust (120F/49C)
● Power supply hot spot status
Table 546: Power Supply Temperature Test (#1537) 1 of 2
Error
Code
Test
Result
Description and recommendation
1000 ABORT Internal software error.
1. Repeat the command at one-minute intervals 1 to 3 times.
1035 ABORT The port network is not available.
1. Enter status port-network to verify that the network is not up.
2. Look for alarms against EXP-PN (Expansion Port Network),
EXP-INTF (Expansion Interface Circuit Pack), PKT-INT (Packet
Interface) etc.
3. Use the diagnostic procedures for those MOs to clear the problem.
2029 ABORT There is a problem communicating with the environmental maintenance
firmware.
2100 ABORT The system could not allocate resources.
1. Repeat the command at one-minute intervals 1 to 3 times.
2319 ABORT The EPN is out of range.
2500 ABORT An internal operation failed.
1. Repeat the command at one-minute intervals 1 to 3 times.
1702 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2