Demand test descriptions and error codes - Avaya Support

Table 515: RC Tone Loopback Test (#1343) 2 of 2
Error
Code
3001
3002
3003
3004
3005
3006
FAIL One or more of the 24 tone loopback tests failed.
1. Replace the RC circuit pack.
4001 FAIL The tone loopback tests that use DSPs 1 - 3 failed.
1. Replace the RC circuit pack.
4002 FAIL The tone loopback tests that use DSPs 4 - 6 failed.
1. Replace the RC circuit pack.
62524
62525
62526
Test
Result
ANY NO
BOARD
ANY EXTRA
BD
Description / Recommendation
RC Tone Loopback Test (#1343)
ABORT Resources required to do maintenance activity on this circuit pack are
not available.
1. Resolve alarms and retry the test.
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be
changed only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the
RC is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
Only a specific number of certain circuit packs can be in the system or
port network. Only one Maintenance Test circuit pack is allowed per
port network. 10 Tone Detector or Call Classifier circuit packs are
allowed.
PASS The RC board is functioning normally.
2 of 2
Issue 5 May 2009 1645