Demand test descriptions and error codes - Avaya Support

ASAI-PT (ASAI Port)
d. Error Type 1537: The port received an invalid frame over the D-Chel. This error is most
likely due to a problem with the wiring to the set or adjunct, interference on the wiring due to
a noise source, or no termination (an open circuit). It usually does not indicate a problem
with the circuit pack.
● Check the wiring to the endpoints or the adjunct.
● If the problem persists, replace the endpoints or adjuncts.
e. Error Type 3841: a Layer 1 Transmission error is detected for the port. Run the long test
sequence, and note the results of the Layer 1 Transmission Error Counter Test (#624).
f. Error Type 3844: the circuit pack detects an overflow of its receive buffers. Run the long
test sequence, and note the results of the Receive FIFO Error Counter Test (#625).
g. Error Type 3845: the BRI Port Local LAN Looparound Test (#618) fails. Run the long test
sequence, and note the results of Test #618.
h. Error Type 3846: the TEI (Terminal Endpoint Identifier) administered for the ASAI endpoint
most likely does not match the TEI administered in the ASAI adjunct. Check the switch
administration of the TEI against that of the adjunct, and make sure that both are using the
same TEI.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of Investigation Short Test
Sequence
Long Test
Sequence
BRI Port Local LAN Looparound Test (#618) X D
1. D = Destructive, ND = Nondestructive
D/ND 1
Level 1 Status Inquiry Test (#621) X X ND
CRC Error Counter Test (#623) X ND
Layer 1 Transmission Error Counter Test (#624) X ND
Receive FIFO Error Counter Test (#625) X ND
Clear Error Counters Test (#270) X X ND
Issue 5 May 2009 113