Demand test descriptions and error codes - Avaya Support

Table 380: Service State Audit Test (#256) 2 of 2
Error
Code
Test
Result
Description / Recommendation
Service State Audit Test (#256)
1114 ABORT Signaling link in transitional state
1. Retry the command up to 5 times at 1-minute intervals.
1116 ABORT The trunk is not in a service state which is appropriate for running the test.
This test is only performed in the OOS/FE state.
1117 ABORT A service state audit message is outstanding
1. Wait 2 minutes, then try again.
1700 ABORT PE-BCH: Rollabout video abort. The PRI terminal adapter associated
with this PRI endpoint extension is detached from the circuit pack. This is
a normal abort when the rollabout video feature is enabled.
1. Either reconnect the disconnected PRI terminal adapter or disable
the rollabout video feature on this circuit pack. To do the latter,
enter change ds1 location and set the Alarm when PRI
Endpoint Detached? field to y.
2100 ABORT Could not allocate needed resources
1. Retry the command up to 5 times at 1-minute intervals.
FAIL Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
PASS Wait 4 minutes, then check the Error Log for any new errors of type
3073.
1. If there are no new errors of type 3073, then both sides of the ISDN
connection agree on the service state. The negotiation succeeded.
2. If there is a new error of type 3073, the negotiation failed. The
system will automatically retry approximately every 15 minutes. If
the port was initially in the INS (in-service) state, it will now be
placed in the MTC/FE (maintenance, far-end problem) state.
Incoming calls will be accepted, but no outgoing calls will be
originated this port. If an incoming call is presented, another
Service State audit will be immediately performed in an attempt to
bring the port into the proper state.
2 of 2
Issue 5 May 2009 1333