Demand test descriptions and error codes - Avaya Support

Table 310: Analog Line Station Lamp Update Test (#60) 1 of 2
Error
Code
Test
Result
Description / Recommendation
Analog Line Station Lamp Update Test (#60)
1 ABORT This port may have been busied out.
1. Look in the Error Log for Error Type 18 (port busied out) for this port.
If this Error Type is present, then release the port using release
station extension and run the test again.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
3 ABORT The station is in ready-for-service or out-of-service state. This may be due
to wiring or an unplugged or defective set.
1. Make sure the terminal is connected and the wiring is correct.
2. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Enter display port location to determine the station extension
of the port.
2. Enter status station to determine the service state of the port. If
the port is in use, wait until the port is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using either display port (the
port is a TTI port) or list config (shows a t for the port).
2. If list config or display port indicate that the port is not a
TTI port, escalate the problem. If both commands indicate that the
port is a TTI port, the abort is correct, and no action is necessary.
FAIL Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
PASS Analog Line Station Lamp Update Test completed successfully.
1. If complaints persist, investigate by using other circuit pack tests,
and by examining the station, wiring, and connections.
1 of 2
Issue 5 May 2009 1171