Demand test descriptions and error codes - Avaya Support

This test is run for ANL-LINE (8-Port Analog Line).
Table 300: Looparound and Conference Test (#47) 1 of 5
Error
Code
Test
Result
Description / Recommendation
Looparound and Conference Test (#47)
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
7 ABORT The port was seized by a user for a valid call.
1. Enter display port location to determine the station’s
extension.
2. Enter status station extension to determine the service
state of the port. If the port is in use, wait until the port is idle before
retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test were not available. The port
may be busy with a valid call. This could be a Music-on-Hold port.
1. Enter display port location to determine the station’s
extension.
2. Enter status station extension to determine the service
state of the port. If the port is in use, wait until the port is idle before
retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may
be under heavy traffic conditions, or it may have time slots
out-of-service due to TDM-BUS errors. A system is considered under
heavy traffic when the Call Processing Occupancy is greater than 50%
or when the System Management and the Call Processing Occupancies
together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1 of 5
Issue 5 May 2009 1147