Demand test descriptions and error codes - Avaya Support

Expansion Interface Reset Test (#336)
If the reset command returns “PN is unavailable,” perform the following steps:
1. Enter change circuit-pack P, where P is the Port Network number.
2. For the EI circuit pack you wish to reset, add an entry to the Circuit Pack screen for the
TN570 EI circuit pack. Be sure to enter the appropriate carrier and slot.
3. Submit the screen.
4. Enter busyout board location
5. Enter reset board location
This test runs on EXP-INTF (Expansion Interface Circuit Pack).
Table 394: Expansion Interface Reset Test (#336) 1 of 3
Error
Code
Test
Result
Description / Recommendation
4 ABORT The neighbor EI circuit pack or SNI circuit pack is not recognized by the
system. The circuit pack is not inserted.
1. Insert neighbor EI circuit pack or SNI circuit pack and perform the
reset again.
1015 ABORT The EI circuit pack has not been busied out.
1. Busyout the EI circuit pack with busyout board location.
2. Enter reset board location.
3. Retry the command.
2000 ABORT Response to the test was not received within the allowed time.
2100 Could not allocate the necessary system resources to run this test.
2500 Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1 of 3
Issue 5 May 2009 1359