Demand test descriptions and error codes - Avaya Support

Environmental Maintenance Initialization Test (#1548)
When a TN2312BP IPSI is inserted in a G650, Communication Manager sends the following
messages to embedded software (firmware) on the board:
● Enable environmental maintenance
● Enable power supply insertion
● Enable power supply audits
● A query to verify that environmental maintenance is enabled
● A query to verify that power supply insertion is enabled
● A query to verify that power supply audits are enabled
This test runs on CAB-MTCE (Media Gateway Maintenance).
.
Table 553: Environmental Maintenance Initialization Test (#1548)
Error
Code
Test
Result
Description and recommendation
1000 FAIL Internal system error.
1. Repeat the command at one-minute intervals up to 3 times.
1986 ABORT Set Emergency Transfer failed.
1. Repeat the command at one-minute intervals up to 3 times.
2000
2033
2500
FAIL No response received within the allowed time.
Internal system error.
Internal operation failed. Possible unknown cabinet type.
1. Repeat the command at one-minute intervals up to 3 times.
FAIL The TN2312BP in carrier A is missing. This test will also fail if an
incorrect response or no response from firmware is received when the
board is queried.
1. Ensure that there is a TN2312BP in the A carrier.
2. Repeat the command at one-minute intervals up to 3 times.
PASS Environmental maintenance initialization was successful.
Issue 5 May 2009 1711