Demand test descriptions and error codes - Avaya Support

Table 473: VC DSP Port NPE Crosstalk Test (#1103)
Error
Code
1000
1001
Test
Result
Description / Recommendation
VC DSP Port Local TDM Loopback Test (#1104)
ABORT System resources required to run this test are not available.
The port may be busy with a valid call.
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources for this test.
1. Retry the command at 1-minute intervals up to 5 times.
0-3 FAIL The NPE of the tested port was transmitting in error, causing noisy and
unreliable connections.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
1. To be sure that this is not an intermittent problem, repeat this test up
to 10 times.
2. If complaints still persist, examine the station, connections, and
wiring.
VC DSP Port Local TDM Loopback Test (#1104)
This test is destructive.
This test verifies the connectivity of a VC DSP Port across the TDM bus. It aborts if calls
associated with the port are in progress. Failure of this test indicates an on-board fault
associated with the port hardware on the circuit pack. The Loopback Test runs a looparound
test across the TDM bus, and a conference circuit test.
The tests are run in the listed order. If one test fails, an Error Code is returned and the remaining
tests in the sequence are not executed. This test runs on VC-DSPPT (Voice Conditioner DSP
Port).
Issue 5 May 2009 1561