Demand test descriptions and error codes - Avaya Support

Table 412: BRI NPE Crosstalk Test (#617) 2 of 2
Error
Code
2012
2100
1
2
Test
Result
Description / Recommendation
BRI Port Local LAN Looparound Test (#618)
BRI Port Local LAN Looparound Test (#618)
ABORT Internal system error.
Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The test failed on Chel B1.
The test failed on Chel B2.
The NPE of the tested port was found to be transmitting in error. This
causes noisy and unreliable connections.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
1. To verify that this is not an intermittent problem, repeat this test up
to 10 times to make sure it continues passing.
2. If complaints still exist, examine the station, connections, and
wiring.
This test is destructive.
This test checks the connectivity of a BRI port across the LAN Bus and executes only if the port
is out-of-service. The test aborts if calls associated with the port are in-progress. Failures of this
test indicate either on-board faults associated with the port hardware on the circuit pack or
problems with the LAN Bus.
This test runs on the following maintenance objects:
● ASAI-PT (ASAI Port)
● BRI-PORT (ISDN-BRI Port)
● TBRI-PT (ISDN Trunk-Side BRI Port)
2 of 2
Issue 5 May 2009 1397