Demand test descriptions and error codes - Avaya Support

EMG-XFER (Emergency Transfer)
MO Name in Log Alarm Level Initial Command to Run 1
EMG-XFER MAJ
WRN
1. UU is the universal cabinet number listed in the PORT field of the Alarm or Error Log.
EMG-XFER (Emergency Transfer)
The maintenance software for Emergency Transfer monitors the position of the Emergency
Transfer switch(es) on the EPNs’ Maintenance circuit packs. It does not monitor whether the
system is actually in Emergency Transfer.
Emergency Transfer (ET) provides the ability to connect designated analog phones to CO
trunks when the switch cot provide minimal phone service.
Emergency Transfer is automatically controlled by the system or can be manually controlled via
the Emergency Transfer switch located on the Maintenance circuit pack. A manual ON position
(up) generates a Major alarm. A manual OFF position (down) generates a Warning alarm.
Unless a technician is currently working on the system, the switch should be left in the auto
position.
Emergency Transfer Status
The status cabinet UU command shows the location of the ET switches and the current
status of ET in the designated cabinet as follows:
Error log entries and recommended actions
Full Name of MO
test environment UU Emergency Transfer
auto+ ET is invoked and under system control.
auto- ET is not in effect and is under system control (normal operating state).
unavailable The switch setting(s) is not available.
Table 102: EMG-XFER Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test environment UU
1 (b) 0 Emergency Transfer Query
(#124)
MAJ ON test environment UU r 3
Issue 5 May 2009 405