Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 504: TCP/IP Ping Test (#1281) 3 of 3
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
1002 FAIL Ping pipe write failure. The C-LAN has too many ping requests buffered,
and there is no room to buffer more.
1. Reset the C-LAN circuit pack and retest.
2. If the test fails again, replace the C-LAN circuit pack.
1003 FAIL Ping to the destination failed due to an on-board problem.
1. Retry the command at 1-minute intervals, up to 3 times.
2. If the problem persists, reset the circuit pack and rerun the test.
3. If the problem persists, re-administer the PPP/Ethernet connection
through a different PPP/Ethernet port, if available.
4. If the problem still persists, or if there are no other available PPP/
Ethernet ports, replace the circuit pack.
1007 FAIL Ping to the destination failed due to the destination being down.
1. Verify that at least one destination reachable through this port is
up. Ping this destination (ping ip-address
xxx.xxx.xxx.xxx).
2. If the ping to any destination is successful through this port, the link
is up, although some destinations are unreachable. Ignore the
failure.
3. If the ping to every destination fails, test the port with
test port location, and follow the repair procedures for
Session Status Test (#1286) failures.
PASS TCP/IP Ping test (#1281) is successful.
1624 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3