Demand test descriptions and error codes - Avaya Support

Table 286: Conference Circuit Test (#7) 4 of 7
Error
Code
Test
Result
Description / Recommendation
Conference Circuit Test (#7)
1004 ABORT The port was seized by a valid call during the test.
DAT-LINE:
1. Enter status data-module to determine if the port is idle.
2. If the port is idle, retry the test at 1-minute intervals up to 5 times.
PE-BCHL:
1. Enter status pri-endpoint extension to determine if the
port is idle.
2. If the port is idle, retry the test at 1-minute intervals up to 5 times.
WAE-PORT:
1. Enter status access-endpoint extension to determine if the
port is idle.
2. If the port is idle, retry the test at 1-minute intervals up to 5 times.
For all other Maintenance Objects:
1. Enter display port location to determine the trunk group/
member number or station extension of the port.
2. Enter status trunk or status station
extension to determine the service state of the port. If the port is
in use, wait until it is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT The test is not applicable for this port. This error can be ignored.
1018 ABORT The test has been disabled by administration. This may be due to the
ONS Ringer Application Test #48, which can be customer or terminal
disturbing.
1. To enable the test for a particular station, enter change station
extension and set the Maintenance Tests field on the Station
screen to y. Submit the screen.
2. Retry the command at 1-minute intervals up to 5 times.
4 of 7
Issue 5 May 2009 1095