Demand test descriptions and error codes - Avaya Support

● AN-LN-PT (Analog Line Port)
● ANL-16-L (16-Port Analog Line)
● ANL-LINE (8-Port Analog Line)
● AUX-TRK (Auxiliary Trunk)
● CO-DS1 (DS1 CO Trunk)
● CO-TRK (Analog CO Trunk)
● DAT-LINE (Data Line Port)
● DID-DS1 (Direct Inward Dial Trunk)
● DID-TRK (Direct Inward Dial Trunk)
● DIOD-DS1 (DS1 DIOD Trunk)
● DIOD-TRK (DIOD Trunk)
● ISDN-TRK (DS1 ISDN Trunk)
● OPS-LINE (DS1 Off-Premises Station Line)
● _PE (Processor Ethernet) Alarms
● RANL-STA (Remote Analog Line (Station) Port)
● TIE-DS1 (DS1 Tie Trunk)
● TIE-TRK (Analog Tie Trunk)
Port Audit And Update Test (#36)
This test is also known as the Station Status and Translation Audits and Updates Test (#36)
Table 294: Port Audit and Update Test (#36) 1 of 4
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test were not available. The port
may be busy with a valid call.
1. Enter display port location to determine the station
extension or trunk group/member number of the port.
2. Enter status station or status trunk to determine the
service state of the port. If the port is in use, wait it is idle before
retesting.
3. If the port is idle, retry the command at 1-minute intervals a
maximum of 5 times.
1 of 4
Issue 5 May 2009 1131