Demand test descriptions and error codes - Avaya Support

Table 220: RC-BD Error Log Entries 2 of 2
Error
Type
1281 (k) RC NPE Audit
(#1336)
MIN ON
1537 (l) Hyperactive
Angel
MIN ON
1793 (m) RC Tone
Loopback Test
MIN ON
2049 (n) RC NPE Port
Loop Test (#1316)
MIN ON
2305 (o) Firmware
Checksum Error
MIN ON
2561 (p) Firmware
Upgrade Error
MIN ON
2817 (q) RC Data
Relations Audit
WRN OFF
3073 (r) MIN ON
3329 (s) MIN OFF
3585 (t) WRN OFF
3841 (u)
Aux
Data
Associated Test Alarm
Level
On/Off
Board
RC-BD (Radio Controller Board)
Recommended Action
2 of 2
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 1: the circuit pack stopped functioning or has been physically removed from the
system. The alarm is logged approximately 11 minutes after removal of the circuit pack or
failure of the SAKI Sanity Test (#53).
Check for the physical presence of the circuit pack in the slot indicated by the alarm. If the
circuit pack is absent, insert one of the proper type. If the circuit pack is present and its red
LED is lit, see LED alarms without Alarm Log entry or with Error Type 1 in LED
Descriptions for Avaya Aura Communication Manager Hardware Components
(03-602804).
c. Error Type 18: the circuit pack has been busied out. Release the circuit pack using
release board location.
Issue 5 May 2009 799