Demand test descriptions and error codes - Avaya Support

Table 423: BRI XID Test (#628) 4 of 4
Error
Code
Test
Result
Description / Recommendation
BRI Layer 3 Query Test (#629)
BRI Layer 3 Query Test (#629)
2000 FAIL The XID-RESPONSE message was not received from the endpoint.
1. Consult the endpoint’s documentation to determine whether layer-2
XID and XID-RESPONSE messages are supported. If the
documentation reflects no support for these messages, use
change station extension and change the XID Testing field
to n.
2. If the endpoint supports these layer-2 messages and the test
continues to fail, assume the endpoint is defective and replace it.
3. If the test continues to fail, escalate the problem.
PASS The switch can successfully pass messages over the D-Chel to the BRI
endpoint.
4 of 4
The BRI Layer 3 Query Test checks the application layer communications between the switch
and the endpoint or adjunct.
For BRI endpoints, an application message containing the appropriate endpoint service state is
sent by the switch to the endpoint. The endpoint responds with an acknowledgment to the
application message.
This test is not executed for ASAI and Avaya adjuncts from the administration terminal. Rather,
a query message is automatically sent by the switch every two minutes. Failure of the switch to
receive a response to a query from the adjunct is logged in the Error Log.
This test is run on BRI-SET, Various Adjuncts.
Issue 5 May 2009 1421