Demand test descriptions and error codes - Avaya Support

Table 390: Battery Holdover Hardware Verification Test (#311)
Error
Code
1000
2000
2029
2500
Test
Result
Description/ Recommendation
DS1 OPS Switchhook Inquiry Test (#312)
DS1 OPS Switchhook Inquiry Test (#312)
ABORT System resources required to run this test are not available.
Response to the test was not received within the allowed time.
Internal system error.
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The hardware vintage of the PN’s Maintenance circuit pack does not
support battery holdover for all carriers.
This failure indicates that the cabinet administration is set for battery
holdover for all carriers.
1. Verify cabinet administration. Make sure that the battery holdover
feature is administered correctly, and that cabinet administration is
not set for battery holdover for all carriers.
2. Retry the command at 1-minute intervals up to 5 times.
PASS The cabinet administration shows battery holdover for A carrier only. Also,
the hardware vintage of the PN’s TN775D Maintenance board is correct.
This test queries the switchhook state of the Off-Premises-Station in switch software. If the state
in switch software disagrees with the state on the DS1 Interface circuit pack, then the state in
the switch software is updated to match the state on the DS1 Interface circuit pack.
This test runs on OPS-LINE (DS1 Off-Premises Station Line).
Table 391: DS1 OPS Switchhook Inquiry Test (#312) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1 of 3
Issue 5 May 2009 1351