Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 440: SNI-BD Configuration Audit (#759) 2 of 6
Error
Code
Test
Result
Description / Recommendation
2306 ABORT The SNI circuit pack is not responding to test requests sent by software.
1. Run test led switch-node for the switch node where this board
resides to verify whether the LEDs on the board light.
2. If the LEDs on the other boards in the carrier light, but the LEDs on
this board do not light, run Test #760 using test board location
long for the active SNC in this carrier. Wait 5 minutes and then try
step 1 one more time. If the LEDs on this board still do not light,
replace this board. Replacing an SNI may be service interrupting.
See SNI-BD (SNI Circuit Pack) for the procedure for replacing an
SNI.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this
carrier to the server.
a. Check list fiber-link to see the fiber connections to this
carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for
any EXP-INTF error entries associated with the controlling IPSI
connected PN.
d. Follow the repair procedures for any SYNC, SNI-BD, SNC-BD,
FIBER-LK, or SNI-PEER error entries.
4. Follow the Switch Node Interface Manual Loopback Procedure to
determine whether the circuit pack or the fiber connection is faulty.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1474 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 6