Demand test descriptions and error codes - Avaya Support

4-Character LED
The 4-character LED displays the circuit pack status related to the Ethernet interfaces. If
automatic IP address assignment via DHCP is enabled, the top character displays the Switch ID
and the next two characters display the Cabinet Number. The last character is used to display
the link status of the two Ethernet interfaces.
Services Interface
The top RJ45 jack is the services interface. This is a 10/100 BaseT Ethernet interface.
Control Network Interface
The bottom RJ45 jack is the control network interface. This is a 10/100 BaseT Ethernet
interface. This interface is active only when the IPSI I/O adapter is not plugged onto the
Amphenol connector, located on the rear of the carrier.
PN’s Maintenance Board Interface
The PN’s Maintenance board interface is a header on the IPSI circuit pack with a slit on the
faceplate of the IPSI for the ribbon cable to connect to the PN’s TN775D Maintenance board.
Error log entries and recommended actions
Table 154: IP-SVR Error Log Entries
Error Type Aux
Data
18
The IPSI circuit
pack is busied out
by maintenance
personnel.
Demand tests descriptions and error codes
There are no demand tests for IP-SVR.
Associated Test Alarm
Level
0 busyout
ipserver-interface
location
On/Off
Board
544 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Recommended Action
WRN OFF release
ipserver-interface
location