Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 361: Playback Speech Memory Array Test (#206) 1 of 2
Error
Code
Test
Result
Description/ Recommendation
1000 ABORT System resources required to run this test are not available. The port
may be in use on a valid call.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1024 ABORT Announcement circuit pack blocked the test because an announcement
download is in progress. If an announcement download is in progress,
status data-module should
show that the announcement data port is connected to a NETCON data
chel, and the memory card should be active. (To determine the extension
of the announcement data module, use list data-module.)
See Note (a) at the end of the table for Test #205 for more information.
1. Wait until download is finished. It could take a maximum of 45
minutes. Then run the test again.
2. If the test continues to abort and there is no download in progress,
escalate the problem.
1286 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2