Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 499: ATM Board Framer Looparound Test (#1260) 2 of 5
Error
Code
Test
Result
Description / Recommendation
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1015 ABORT The ATM-EI or ATM-TRK circuit pack has not been busied out.
1. Busyout the ATM circuit pack, then rerun the test.
1031 ABORT If the ATM Expansion Interface circuit pack is in a PN and is on the active
PNC, this test cot be executed.
1. If PNC Duplication is enabled, attempt to make the standby PNC
active using reset pnc interchange.
2. If the PNC Interchange is successful, rerun the test.
1033 ABORT Circuit pack not found.
ATM-EI:
1. Enter list atm pnc to verify the switch recognizes the circuit
pack.
2. Retry the command.
ATM-TRK:
1. Enter status trunk-group to verify the switch recognizes the
circuit pack.
2. Retry the command.
1139 ABORT Major Alarm on the PN’s packet bus.
1. Resolve any PKT-BUS (Packet Bus) problems.
2. Retry the command.
1614 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 5