Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
140AY Looparound Test (#210)
This test checks the integrity of the record chel on the announcement circuit pack
(Announcement Port 1).
Since this test involves sending a tone through two different ports, the Playback Speech
Memory Array Test (#206) is run on the two ports first to make sure that they are working
properly.
This test runs on -BD (Announcement circuit pack).
Table 364: 140AY Looparound Test (#210) 1 of 3
Error
Code
Test
Result
Description/ Recommendation
1-3 ABORT Response to the test was not received within the time allowed. The error
code indicates at which speech compression rate the test aborted (one
being the first rate tested, three being the last).
1. Retry the command at 1-minute intervals a maximum of 5 times.
10 ABORT The PSMA Test (#206) failed on announcement Port 1.
90 The PSMA Test (#206) failed on announcement Port 9.
1. Refer to Playback Speech Memory Array Test (#206).
1000 ABORT System resources required to run this test are not available. This test
needs Announcement Ports 1 and 9 to run. One of the ports may be in use
on a valid call.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort and Ports 1 and 9 are not in use,
escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due
to TDM-BUS errors. A system is considered under heavy traffic when the
Call Processing Occupancy is greater than 50% or when the System
Management and the Call Processing Occupancies together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1292 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3