Demand test descriptions and error codes - Avaya Support

Error log entries and recommended actions
Table 232: SNC-BD Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
SNC-BD (Switch Node Clock Circuit Pack)
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test board location
1 (b) Any Failure audit (#777) MAJ ON test board location
18 (c) 0 busyout board location WRN OFF release board location
257 (d) Any Failure audit (#777) MAJ OFF test board location
513 (e) Any Failure audit (#777) MIN OFF test board location
769 (f) Any Failure audit (#777) MIN OFF test board location
1025 (g) Any Failure audit (#777) MAJ ON test board location
1281 (h) Any Failure audit (#777) MIN OFF test board location
1537 (i) Any Failure audit (#777) MIN ON test board location
1793 (j) Any Failure audit (#777) MAJ ON test board location
2049 (k) Any Failure audit (#777) MAJ ON test board location
6008 (l) 0 SNC Release/Busy
(#781)
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: SNC on-board microcontroller error. Replace the SNC circuit pack.
c. Error Type 18: the SNC circuit pack was busied out using busyout board location. To
resolve this error, use release board location to release the SNC circuit pack.
d. Error Type 257: firmware detects failure of the phase-locked loop, inability to lock, or failure
of the clock drivers. The problem is off-board.
1. Enter display errors. If SNC-BD Error Type 1793 exists in the error log, follow the
repair procedures for SNC-BD Error Type 1793.
2. Enter display errors. If no SNI-BD 1025 errors exist in the error log, replace the
active SNC.
3. Enter display errors. If any SNI-BD 1025 errors exist in the error log, follow the
repair procedure in SNI-BD (SNI Circuit Pack) for these errors.
Issue 5 May 2009 851