Demand test descriptions and error codes - Avaya Support

Table 284: Battery and Power Supply Query Test (#5) 3 of 7
Error
Code
2029
2319
2320
2500
Test
Result
Description / Recommendation
Battery and Power Supply Query Test (#5)
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2 FAIL DC-powered cabinet: The PN’s Maintenance circuit pack is
incorrectly reporting a problem with power. Replace the suspect circuit
pack and run the test again.
AC-powered cabinet: The system is in nominal power holdover, and
the battery is so low that the system will disconnect power very shortly.
1. If power returns, the port carriers in the PN should power-up
again. Every circuit pack should be reinserted, and the system
should continue to operate normally. There will probably be a
minor alarm against battery and battery charger due to the fact
that the batteries are recharging.
2. If power does not return, the system will shut down to prevent
damage to the batteries. Restore power, and the system will
reboot. No manual intervention is required.
3. Rerun the test. If the test still fails, the PN’s MAINT (Maintenance)
circuit pack could be reporting this condition incorrectly. Resolve
every alarm on this MO, and rerun the test. There are failures that
can occur on the PN’s Maintenance circuit pack that will not be
detected by their respective maintenance, but which will cause
many, if not every, environment tests to fail. If many environment
tests are failing, the suspect circuit pack, depending on the
system configuration, should be replaced and the test rerun.
3 of 7
Issue 5 May 2009 1079